This is an important one. Just imagine working for eight hours on a panel and at the end you just have to make a bend that takes you ... five minutes. If you miss it, you can start all over again. This bend is important for the look of the car. Some do a right angle, but to my taste it is essential that it has a radius of about 25mm. Just like a broomstick! Well, that's what I took to bend the panel.
Then I had to have a look with the nose and bonnet on. Still a lot of adaptation required before everything fits, but all in all a good start.
Exhaust manifold exit ... fits!
Cheers.
No comments:
Post a Comment